Esterline CMA-9000 - Page 109

OPERATOR’S MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
7. The flight level can be changed at any waypoint. Press the CLR key. DELETE is displayed in the
scratchpad.
Delete the flight level by pressing either LSK 1L, 2L, 3L, or 4L. Next, re-enter a new flight level and wind as
described above.
NOTE: The new flight level and wind is propagated throughout the flight plan. The same four flight levels are
used throughout the flight plan, but each waypoint can have its specific wind entries.
8. Return to the LEGS WIND page by pressing LSK 6R.
Waypoints where a wind entry was made have a filled-in prompt, whereas where no entry was made, the
prompt is a “greater than” symbol.
9. On the LEGS WND page, the displayed wind data is the result of the blending of measured wind at aircraft
position with waypoint wind. This blended wind is used for the calculation of ETAs.
1R
2R
3R
4R
5R
ACT RTE1 LEGS WND 2/4
ETA WIND
CAFTA 1916.4Z 140
T
/ 30>
YZP
1950.2Z 140
T
/ 30>
MOCA1 2000.7Z 140
T
/ 30>
BKA 2044.5Z 140
T
/ 30>
KILLA
2127.0Z 140
T
/ 30>
<LEGS ETA LEGS POS>
1L
2L
3L
4L
5L
6L
6R
Page 5-16
August 17, 2010
DRAFT