OPERATOR’S MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
Page A-41
August 17, 2010
TYPE/CLASS (4L), (4R) upper line: Display of identifier type or VHF NAVAID class. Possible values are:
AIRPORT: Airports
NDB: Non-Directional Beacon waypoint
WAYPOINT: Simple Position Waypoint
VHF Navigation Aids classes: a/b/c
a
b c
DME C - Co-located H - High Level
ILSDME N - Non co-located L - Low Level
ILSTACAN O - Out of Service T - Terminal
LOCGS * - N/A U - Undefined
LOCONLY
MLSDMEN
MLSDMEP
TACAN
VNCDME(DME component
of a VORDME)
VNCTACAN
(TACAN component of a
VORTAC)
VOR
VORDME
VORTAC
ELEVATION (4L), (4R) lower line: Display of elevation in feet (Airport and VHF NAV only).
FREQ (5L), (5R) upper line: Display of NAVAID frequency (MHz) (DME, ILSDME, VOR, and VORDME VHF
NAV only).
DECLIN (5L), (5R) lower line: Display of VOR Station Declination (VHF NAV only).
MAGVAR (5L), (5R) lower line: Display of magnetic variation (WAYPOINT, AIRPORT, NDB NAVAID, ILS).
NEW USER WPT [6L]: Displayed only for non-user waypoints. Access the USER WPT pages allowing creation
of a new user waypoint or modification of any field of an existing one. This prompt selection is only available
when the USER DBASE configuration option is enabled.
EDT/NEW WPT [6L]: Access the USER WPT pages allowing modification of any field of the selected
waypoint or creation of a new user waypoint. The user waypoint data being displayed will automatically appear
on the USER WPT pages.
(SAVE?): Displayed between the CANCEL/CONFIRM prompts when the inactive route is in modification.
(DELETE?): Displayed between the CANCEL/CONFIRM prompts when the inactive route is in modification.
CANCEL [6L]: Cancels the modifications performed to a user waypoint.
CONFIRM [6R]: Confirms the modifications performed to a user waypoint.
To Next Page
Loading...