OPERATOR’S MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
INIT/REF [6L]:
ERASE [6L]:
"INIT/REF" is displayed when there is no active flight plan modification in progress. Pressing the LSK provides
direct access to the INIT/REF INDEX 1/2 or 2/2 page.
"ERASE" is displayed when an active flight plan modification is in progress. Pressing this key will undo all
changes to the active flight plan and return to the ACT Route status.
DERATE-FLEX[1R]: On ground, allows crew entry and display of the takeoff FLEX temperature or takeoff
thrust de-rate. Valid entry for Flex temperature an “F” followed by a one or two digit integer within the PDB
defined range (e.g. F41) while a valid entry for thrust de-rate is a “D” followed by a one or two digit integer
divisible by 5 within the PDB defined range (e.g. D10).
ACCEL HT [2R]: Allows crew entry and display of the Acceleration Height.
NOTE: ACCEL HT is the altitude above the takeoff runway elevation at which the FMS target speed switches
from the selected takeoff speed (e.g.: V2 +10) to the initial climb speed. The ACCEL HT has a default
value coded in the Policy File (typically the default value is 3,000ft AGL).
THR RED HT [3R]: Allows crew entry and display of the Thrust Reduction Height.
NOTE: THR RED HT is the altitude above the takeoff runway elevation at which the commanded thrust is
reduced from Take-off to Climb thrust. The THR RED HT has a default value coded in the Policy File
(typically the default value is 1,500ft AGL).
ROUTE [6R]: Enables direct access to RTE 1/X page.
Page RRJ-A-6
August 17, 2010
To Next Page
Loading...