OPERATOR’S MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
SPD REST [3L]: Entry and display of the descent Speed Restriction/Speed Restriction Altitude.
Defaults to the value from the navigation database - 10 knots..
Manual entry is allowed. The valid range of manual entry is defined in the PDB
Format of manual entry is speed and/or altitude, using the slash rule e.g. 250, 250/10000 or /10000. Deletion of
a manual entry reverts the data field to the default value extracted from the navigation database, if available,
otherwise to dashes. Deletion of the values extracted from the navigation database is not allowed.
Manual entry is displayed in large white font. Default value or value extracted from the navigation database is
displayed in small white font. The data field displays dashes (---/----) when no values are available.
If the speed restriction is the source of the FMS target speed, it will be displayed in reverse video white.
XXX SPD [4L]: Displays the target speed if the target speed source is one of the following:
•"SPD AT XXX", where XXX is a descent waypoint behind the aircraft
•"LIM SPD", when the FMS target speed is being limited
•"HOLD SPD", when flying a hold when in descent
•"PATH SPD" when the aircraft is above an idle path and targeting a higher speed to capture the path
•"DECEL SPD" if decel has been selected and the aircraft has not captured the path
SCHED [5L]: Enables direct access to DES SCHEDule 1/1 page.
ERASE [6L]: "ERASE" is displayed when an active flight plan modification is in progress. Pressing this key will
undo all changes to the active flight plan and return to the ACT Route status.
AT NNNNN(NN) [1R]:
AT E/D[1R]:
Displays the next descent waypoint with altitude constraint, if any; otherwise, displays "AT E/D" and E/D speed
and/or altitude.
Displays the next descent waypoint speed and altitude constraints when a speed constraint is associated to the
altitude constraint at the waypoint. Displays only the altitude constraint when only an altitude constraint is
associated to the waypoint.
Manual entry of the speed and/or altitude constraint associated to the waypoint in the title is allowed. It overrides
the value(s) from the navigation database and is propagated to/from LEGS page. Deletion of the manually
entered speed/altitude constraint reverts the data field to the database-derived values which are then
propagated to/from the LEGS page. Deletion of the speed/altitude constraint values derived from the navigation
database is not allowed.
Valid manual entry format is XXX/, XXX/AAAA, or /AAAA.
Manual entry or deletion is not allowed when the [1R] title field is displaying "AT E/D".
Manual entry is displayed in large white font. Default or calculated value is displayed in small white font.
Page RRJ-A-24
August 17, 2010
To Next Page