OPERATOR’S MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
TO NNNNN(NN) [2R]:
NNNNNNN [2R]:
TO E/D [2R]:
TO T/D [2R]:
Displays the ETA and DTG to the waypoint displayed in the title field.
The title field displays:
• " " (blank) when CRZ or CLB mode are ACT-ive and the aircraft is more than 150nm from the T/D;
• “TO T/D” when CRZ or CLB mode are ACT-ive and the aircraft is within 150nm from the T/D;
• "TO NNNNN(NN)" OR “NNNNNNN”, the waypoint displayed in [1R] when DES mode is ACT-ive and a
waypoint is displayed in [1R]; or
• The "TO E/D" when DES mode is ACT-ive and no waypoint is displayed in [1R].
The data field data is displayed in small white font. The data field is blank when the title field is blank.
WPT/ALT [3R]:
OR
REF ALT [3R]:
This field can support display and entry of one of the following options:
• Entry and display of the waypoint and waypoint altitude constraint for computation of V/B and V/S in [4R]:
• Default value is the waypoint and altitude constraint specified in [1R].
• Manual entry of a waypoint identifier from the navigation database is allowed only while airborne.
• Valid manual entry format is to enter a waypoint and/or altitude using the slash rule e.g. NNNNN/,
NNNNN/AAAAA or /AAAAA. For NNNNN/ entry, the waypoint must have an associated altitude
constraint. For /AAAAA entry, a waypoint must already be present in the field.
• Deletion of a manual entry reverts the data field to the default [1R] data, if any.
OR
• Entry and display of a target altitude used for computation of the ground distance to this altitude in [4R]:
• Default value is the FGCP-selected altitude.
• Manual entry of a target altitude is only allowed when airborne:
• Altitude entry must be below the current aircraft altitude and at or above the destination airport
elevation if Descent mode is active.
• Altitude entry of must be above the current aircraft altitude and at or below the FMS CRZ ALT if
Climb mode is active.
• Deletion of a manual entry reverts the data field to the FGCP-selected altitude.
Toggling between both options occurs when [3R] is pressed and nothing is displayed in the scratchpad.
For both display options:
• Manual entry is displayed in large white font.
• Default value is displayed in small white font.
• The data field displays dashes while on ground.
Page RRJ-A-25
August 17, 2010
To Next Page