OPERATOR’S MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
AT NNNNN(NN) [1R]:
AT E/D[1R]:
Displays the next descent waypoint with altitude constraint, if any; otherwise, displays "AT E/D" and E/D speed
and/or altitude.
Displays the next descent waypoint speed and altitude constraints when a speed constraint is associated to the
altitude constraint at the waypoint. Displays only the altitude constraint when only an altitude constraint is
associated to the waypoint.
Manual entry of the speed and/or altitude constraint associated to the waypoint in the title is allowed. It overrides
the value(s) from the navigation database and is propagated to/from LEGS page. Deletion of the manually
entered speed/altitude constraint reverts the data field to the database-derived values which are then
propagated to/from the LEGS page. Deletion of the speed/altitude constraint values derived from the navigation
database is not allowed.
Valid manual entry format is XXX/, XXX/AAAA, or /AAAA. Valid manual entry range is defined in the PDB.
Manual entry or deletion is not allowed when the [1R] title field is displaying "AT E/D".
Manual entry is displayed in large white font. Default or calculated values are displayed in small white font.
TO NNNNN(NN) [2R]:
TO E/D [2R]:
TO T/D [2R]:
Displays the ETA and DTG to the waypoint or step point displayed in the title field.
The title field displays:
• " " (blank) when CRZ or CLB mode are ACT-ive and the aircraft is more than 150nm from the T/D;
• “TO T/D” when CRZ or CLB mode are ACT-ive and the aircraft is within 150nm from the T/D;
• "TO NNNNN(NN)", the waypoint displayed in [1R] when DES or APPR mode is ACT-ive and a waypoint is
displayed in [1R]; or
• the "TO E/D" when DES or APPR mode is ACT-ive and no waypoint is displayed in [1R].
The data field data is displayed in small white font. The data field is blank when the title field is blank.
CROSSWIND [3R]: Displays the current crosswind component (Left or Right in knots, direction from which
wind is blowing).
VDEV [4R]: Displays the vertical deviation relative to the FMS computed descent path with a resolution of 10
feet and a range of 0 to 9990.
Positive values indicate that the aircraft is above the pre-computed descent path. Negative values indicate that
the aircraft is below the pre-computed descent path.
The title and data field are displayed when the aircraft has passed the T/D anticipation point or the descent
mode is active. The FMS will blank the title and data field when vertical guidance is not available. When present,
the values are displayed in small white font.
ARR [6R]: Enables direct access to the ARRIVALS 1/X page.
The prompt is only displayed when no approach has been selected.
PROFILE [6R]: Enables direct access to VNAV PROFILE 1/X page.
NO PROFILE [6R]: Indicates that no vertical profile is computed during FMS engine-out climb mode and
consequently, access to the PROFILE page is forbidden.
Page RRJ-A-34
August 17, 2010
To Next Page
Loading...