OPERATOR’S MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
CANCEL E/O [5L]: Cancels the Engine Out mode and provides direct access to the CLB page (sub-mode and
values before engine out condition).
"CANCEL E/O" prompt is displayed when the Engine Out mode is active and there is no flight plan modification.
ERASE [6L]: "ERASE" is only displayed when an active flight plan modification is in progress. Pressing this key
will undo all changes to the active flight plan and return to the ACT Route status.
STAB ALT [1R]: Entry and display of the critical engine out stabilizing altitude.
Manual entry overrides the FMS-computed value. Valid entry range between 3000ft below to 1000ft above the
FMS-computed Engine Out Stabilizing altitude. Deletion of the manual entry reverts to the FMS-computed
engine out Stabilizing altitude value. Deletion of FMS-computed value is not allowed.
Manual value is displayed in large white font. FMS-computed value is displayed in small white font.
NET CEILING [2R]: Entry and display the engine out net ceiling.
Manual entry overrides the FMS-computed value. Valid entry range between 3000ft below to 1000ft above the
FMS-computed engine out net ceiling. Deletion of the manual entry reverts to the FMS-computed engine out net
ceiling value. Deletion of FMS-computed value is not allowed.
Manual value is displayed in large white font. FMS-computed value is displayed in small white font.
NO PROFILE [6R]: Indicates that no vertical profile is computed during FMS engine-out climb mode and
consequently, access to the PROFILE page is forbidden.
Page RRJ-A-61
August 17, 2010
To Next Page
Loading...