Section 9: Dynamics
Euphonix CS3000/2000 Operation Manual 9 - 35
Page 2 Numeric Keypad
Select Filters
*Note: When the filter path is set to main, the sidechain source must be set to main input, as the filters are
always fed from the sidechain source
Page 2 Parameters
Keypad # Parameter Options or value range Type
0 LF Filter TypeLow Pass, Band Pass, High Pass, Notch Switch
Enter LF Filter Frequency 10.3 Hz to 2.64 kHz Rotary
Del Input Level -6 dB, 0 dB, +6 dB, +12 dB Switch
1 HF Filter Type Low Pass, Band Pass, High Pass, Notch Switch
2 HF Filter Frequency 165 Hz to 42.2 kHz Rotary
3 Filter Path* Main Signal Path, Side Chain Switch
4 Side Chain Source Main Input, Key Input, Main Ch 1...8 Switch
5 Side Chain Listen Side Chain to Output (yes), Main VCA to Output Switch
6 Not used
7 Not used
8 Not used
9 Peak Stop 3 dB to 21 dB Rotary
L1 Filters In or Out Switch
L2 Not Used
L3 Not Used
L4 Dynamics Processor In or Out Switch
+/– Dynamics Page # Page 1 or Page 2 Switch
789
456
123
0 Enter Del
Side Chain Listen
Yes/No
HF Frequency
Input Level
(Main Input and Side Chain)
-6/0/6/12 dB
Filter Path Main/SC
LF Frequency
HF Type
LP/BP/HP/Notch
Side Chain Source
Main/Key
LF Type
LP/BP/HP/Notch
Peak Stop
To Next Page
Loading...
