Chapter 4 Function/System Settings and Display
4.2 Advanced Copy Management > show advanced-copy-sessions
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
403
■ Output
When all parameters are omitted:
# Number of EC Sessions : 2
A
# Number of OPC Sessions : 1
B
# Number of QuickOPC Sessions : 1
C
# Number of SnapOPC Sessions : 1
D
# Number of SnapOPC+ Sessions : 1
E
# Number of Monitor Sessions : 1
F
# Number of REC Sessions : 1
G
# Number of XCopy Sessions : 1
H
# Number of ODX Sessions : 1
I
# Number of Mainframe Volume Sessions : 1
J
A: The number of the Advanced Copy type EC sessions
B: The number of the Advanced Copy type OPC sessions
C: The number of the Advanced Copy type QuickOPC sessions
D: The number of the Advanced Copy type SnapOPC sessions
E: The number of the Advanced Copy type SnapOPC+ sessions
F: The number of the Advanced Copy type Monitor sessions
G: The number of the Advanced Copy type Remote Equivalent Copy (REC) sessions
H: The number of the Advanced Copy type XCOPY sessions
I: The number of the Advanced Copy type ODX sessions
J: The number of the Mainframe Copy sessions (Only when GS License is registered)
When a list is displayed:
# SID Gene- Type Volume Source Volume Destination Volume Status Phase Error Requestor
# ration Type No. Name No. Name Code
# 0 1/12 SnapOPC+ Standard 8000 VOLUME0000123456 4000 VOLUME1111123456 Active - 0x00 CLI
A B C D E F G H I J K L
A: The session ID of this system is displayed in decimal number.
B: The generation is displayed only when the type SnapOPC+ is selected.
C: The Advanced Copy type (EC, OPC, QuickOPC, SnapOPC, SnapOPC+, Monitor, REC, ODX, or XCOPY) is displayed.
D: The volume type that is to be copied in the session is displayed.
E: The copy source volume number is displayed.
F: The copy source volume name is displayed.
G: The copy destination volume number is displayed when types other than Monitor are selected.
H: The copy destination volume name is displayed when types other than Monitor are selected.
I: The session status (Idle, Reserve, Active, Error Suspend, Suspend, or Halt) is displayed.
J: The session phase (No Pair, Copying, Equivalent, Tracking, Tracking&Copying, or Readying) is displayed when
EC, QuickOPC, Monitor, or REC is selected.
K: The error code (for details, refer to "Copy session error codes" (page 405)
) is displayed as a 2-digit hexadecimal
number.
L: The requester that started the session (GUI, CLI, SMI-S, SCSI or LAN) is displayed.
To Next Page
Loading...
