360 Upgrade and Maintenance Manual TX120 S3
System board and components
Ê Reinstall the fan module as described in section "Installing the system fan
module" on page 158.
Ê Close the server cover as described in section "Closing the server" on
page 70.
Ê Reconnect all external cables.
Ê If applicable, activate TPM functionality in the system BIOS under Security >
TPM (Security Chip) Setting > Security Chip. For more information, refer to the
"D3049 BIOS Setup Utility for PRIMERGY TX140 S1 / TX120 S3 Reference
Manual".
Ê Reconnect the AC power cord to the power supply unit.
Ê If available, update the system board BIOS to the latest version as described
in section "Updating or recovering the system board BIOS and iRMC" on
page 86.
Ê Verify whether the backup data on the Chassis ID EPROM has been
restored to the system board as described in section "Verifying system
information backup / restore" on page 90.
Ê If customer BIOS settings are not restored automatically, please change the
settings manually (using the information collected during "preliminary
steps"). If you couldn't determine the BIOS version, ask the customer to
reconfigure all BIOS settings and the password.
V CAUTION!
The system event log entry Chassis IDPROM: Restore
successful (see section "Verifying system information
backup / restore" on page 90) is not valid if you updated the system
board BIOS from version 1.15.0 or below to version 1.18.0 or above.
Ê Enable boot watchdog functionality as described in section "Enabling SVOM
boot watchdog functionality" on page 96.
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section "Enabling
BitLocker functionality" on page 103.
To Next Page
Loading...
Need help?
General