TX120 S3 Upgrade and Maintenance Manual 361
System board and components
Ê If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
The following notes are required for TX120 S3p (PYT12Pxxx for Japanese
market).
I Configuration of network settings should be performed by the
customer. For further information, please refer to section "Note on
network settings recovery" on page 346.
Ê If applicable, restore LAN teaming configurations as described in section
"After replacing the system board" on page 107.
To Next Page
Loading...
