Ê Connect the cables according to your configuration see section "Cabling
plans" (figure 300 or figure 301).
V CAUTION!
Applies to LTO3 drive cabling:
For connection to the power supply, do not use the short end of cable
C34. Use the separate cable C35!
Figure 217: Connecting the cables to the LTO3
I Notes on RDX drive USB cabling:
– A USB 2.0 RDX drive may be replaced by a USB 3.0 RDX drive with
previous cabling.
– A USB 3.0 RDX drive may be connected with a USB 2.0 cable to an
onboard USB 2.0 connector with limited performance.
– For full performance, connect the USB 3.0 RDX drive to a USB 3.0
interface card by USB 3.0 cable.
– The USB 3.0 cable cannot be connected to a USB 2.0 RDX drive.
To Next Page
Loading...
