Optimizing B-Mode
LOGIQ 7 Online Help 5-43
Direction 2392536-100 Rev. 1
Selecting TIC Analysis Image Range
A range of frames is selected for the TIC analysis in Cine mode
(before accessing TIC Analysis). Only the frames in this range
are used for the TIC analysis.
If a range is not selected prior to accessing the TIC Analysis, the
system uses the default Cine start and end frames as the default
TIC start and stop frames.
1. The first frame in the analysis series is selected by adjusting
the Start Frame control to the desired frame
OR
using the Trackball or the Frame by Frame control to
select the desired first frame and then selecting the Start
Frame control.
2. The last frame in the analysis series is selected by adjusting
the CINE Last Frame control to the desired frame
OR
using the Trackball or the Frame by Frame control to
select the desired last frame and then selecting the Last
Frame control.
To Next Page
Loading...
Need help?
General
