Measurement and Calculation Setup
LOGIQ 7 Basic User Manual 7-15
Direction 2392206-100 Rev. 1
Measurement and Calculation Setup
When you receive your LOGIQ 7 system, the studies and
measurements are organized for typical work flows. If you want,
you can change this set up. You can specify which studies are in
each exam category, and which measurements and calculations
are in each study. You can change the measurements that are
available on the Touch Panel. The LOGIQ 7 allows you to
quickly and easily set up your system so that you can work most
efficiently.
This section describes how to:
• Change a study to include different measurements
• Add a new study or measurement
• Remove a study from an exam category
• Change measurement parameters
• Create a measurement formula to correctly handle unit
conversions
• Edit user-defined calculations
• Define application-specific measurement parameters
• Specify the default manual calc measurements for a
selected study or folder
To Next Page
Loading...
