Measurement and Calculation Setup
LOGIQ 7 Basic User Manual 7-37
Direction 2392206-100 Rev. 1
Adding a user-defined measurement
You can create a user-defined measurement in a system-
defined folder or in a folder you created.
1. In the Selection menu, select the study or folder where you
want to add the measurement.
2. In the Measurement menu section, select Add
measurement.
The system displays the Add Measurement window.
Figure 7-21. Add Measurement window
3. Do one of the following:
• If you want to create this measurement from a copy of
an existing measurement, select Use copy of, and then
select a measurement from the list. The list includes all
measurements defined for the current exam category
and selected mode.
NOTE: This only applies to OB and Cardiac.
• If you want to use an existing formula, select Insert, and
then select a measurement from the list. The list
includes all measurements defined for the current exam
category and selected mode. You cannot edit this
formula.
• If you want to create a blank new measurement, select
Blank.
To Next Page
Loading...
Need help?
General
