General Measurements and Calculations
7-76 LOGIQ 7 Basic User Manual
Direction 2392206-100 Rev. 1
Volume
The volume calculation can be made from any of the following
measurements:
• One distance
• Two distances
• Three distances
• One ellipse
• One distance and one ellipse
For details on how to make a distance measurement, See
‘Distance measurement’ for more information.
For details on how to make an ellipse measurement, See
‘Circumference and area (ellipse) measurement’ for more
information..
NOTE: IMPORTANT!! If you want to make a volume calculation using
one or two distances, you must select Volume BEFORE you
make the measurements.
To make a volume calculation using one or two distances:
1. Select Volume.
2. Make one or two distance measurements.
3. Select Volume.
The system displays the distances and the volume in the
Results Window.
To make a volume calculation using three distances:
1. Make three distance measurements.
NOTE: Three distances should be done in the dual format mode
(side by side images). One measurement is usually made in
the sagittal plane and two measurements in the axial plane.
To use the dual format mode, press the L or R key on front
panel.
2. Select Volume.
The system displays the distances and the volume in the
Results Window.
To Next Page
Loading...
Need help?
General
