GE LOGIQ 7

OB/GYN
9-42 LOGIQ 7 Basic User Manual
Direction 2392206-100 Rev. 1
Measurement information
This section lists the results of all measurements.
• CUA or AUA – If this field is checked, the system uses the
measurement to calculate the ultrasound age.
• Value – The measured value. If more than one
measurement was made for an item, the system uses the
specified method (average, maximum, minimum, or last) to
determine this value.
• m1–m3 – Up to three measurement values for each item. If
you make more than three measurements, the worksheet
uses the last three.
• Method – When there is more than one measurement for an
item, this specifies the method used to calculate the
measurement value listed in the Value column. Choices are
average, maximum, minimum, or last. To change the
method:
a. Move the Trackball to the Method field.
b. Press Set.
c. Move the Trackball to select from the list.
d. Press Set.
• AGE – The fetal age for this measurement.
• Range – The typical range of fetal age for this
measurement.