OB/GYN
9-64 LOGIQ 7 Basic User Manual
Direction 2392206-100 Rev. 1
To identify each fetus
For measurements, calculations, and worksheet displays, the
system labels each fetus A, B, C, or D. Each fetus is identified
by a letter and the total number of fetuses. For example, fetus
A/3 is fetus A from a total of 3.
When scanning, you can enter information about the fetus
position and placenta location. You can enter the information in
the Patient Data section of the worksheets and the graphs. You
can type up to 23 characters in the FetusPos and PLAC fields.
Figure 9-18. Patient Data section of the OB Worksheet
To Next Page
Loading...
Need help?
General
