Vascular Measurements
LOGIQ 7 Basic User Manual 11-11
Direction 2392206-100 Rev. 1
Auto Vascular Calculation Overview
Auto Vascular Calculation enables the LOGIQ 7 to detect and
identify a cardiac cycle. It allows you to assign measurements
and calculations during live timeline imaging, while the image is
frozen, or in CINE. Peak values are detected for venous flow.
During cardiac cycle detection, the system identifies the cardiac
cycle using calipers, vertical bars, and/or highlighting of timeline
data. Use of identifiers is based on measurements and
calculations selected by an operator for the current application.
The system may place calipers at early systolic peak, peak
systole, minimum diastole and end diastole. Vertical bars may
also be placed to indicate the beginning and end of the cardiac
cycle. The peak and/or mean trace may be highlighted. You can
edit the cardiac cycle identified by the system or select a
different cardiac cycle.
You can select the calculations to be displayed in the M&A
Result window during live scanning or on a frozen image. These
calculations are displayed at the top of M&A Result Window
located adjacent to the image. These calculations are
presettable by application which means you can set up the
default calculations to be displayed for each application.
To Next Page
Loading...
Need help?
General
