Vascular Worksheet
LOGIQ 7 Basic User Manual 11-27
Direction 2392206-100 Rev. 1
To edit a worksheet (continued)
To delete data:
Delete Value key is used to delete value (each measured
value). Whenever particular value is deleted, the group (set) of
the measurement/study value is also deleted from the
worksheet as a group (set). When PS value is deleted, ED and
RI is also deleted if this value was measured as the set of RI
measurement.
1. Select Worksheet from any page of the Vascular
Calculation Touch Panel Menu.
2. To position the cursor at the field you want to delete or
exclude, move the Trackball.
The field is highlighted.
3. Select Delete Value.
For Example:
1. If the user measured RI 4 times, however, latest 3 set of
measurements were displayed in the worksheet.
1. Then, the user deleted PS value of #3 from the worksheet.
2. The whole set of #3 measurements is deleted from the
worksheet and #1 set of measurements is shifted and
displayed as below.
Result Number #2 #3 #4
PS 0.500 0.600 0.700
ED 0.100 0.200 0.300
RI 0.800 0.667 0.571
Result Number #1 #2 #4
PS 0.400 0.500 0.700
ED 0.000 0.100 0.300
RI 1.000 0.800 0.571
To Next Page
Loading...
Need help?
General
