Chapter 9 Inverter Functions
9-6-3
■ When "Torque limit selection [b040]" = "4 quadrant individual setting (00)"
This mode is used to set the torque limit values at the four quadrants - forward power, forward
regenerative, reverse power, and reverse regenerative - individually with "Torque limit 1 to 4
([b041] to [b044])". The relationship between the four quadrants and torque limit values is
shown in the figure below.
■
When "Torque limit selection [b040]" = "Switched by terminal [TRQ1]/[TRQ2] (01)"
As shown in the figure below, parameter settings selected from "Torque limit 1 to 4 ([b041] to
[b044])" based on the combination of the "Torque limit selection bit 1 [TRQ1](41)" and " Torque
limit selection bit 2 [TRQ2](42)" input terminal functions are set as the torque limit value in all
operating conditions.
■ When "Torque limit selection [b040]" = "[Ai1] terminal input (02)"
The torque limit value is specified by the voltage applied to the [Ai1] terminal (analog voltage) of
the control terminal. A voltage input of 0 to 10 V corresponds to a torque limit value of 0 to
200%. The torque limit value entered is applied as the torque limit value for all operating
conditions.
When specifying a torque limit value with an analog voltage input, avoid setting other command
(such as frequency command) inputs to analog inputs.
■ When the "Torque limit selection [b040]" = "Option (03)"
This setting is used to specify the torque limit value from the option board. For details, refer to
the instruction manual of the option board.
To Next Page
Loading...
