About This User Manual D2 Series Servo Drive User Manual
1-2 HIWIN MIKROSYSTEM CORP.
1.1 Instructions before use
Before using the product, please carefully read through this manual. HIWIN Mikrosystem (HIWIN) is not
responsible for any damage, accident or injury caused by failure in following the installation instructions
and operating instructions stated in this manual.
Do not disassemble or modify the product. The design of the product has been verified by structural
calculation, computer simulation and actual testing. HIWIN is not responsible for any damage,
accident or injury caused by disassembly or modification done by users.
Before installing or using the product, ensure there is no damage on its appearance. If any damage
is found after inspection, please contact HIWIN or local distributors.
Carefully read through the specification noted on product label or technical document. Install the
product according to its specification and installation instructions stated in this manual.
Ensure the product is used with power supply specified on product label or in product requirement.
HIWIN is not responsible for any damage, accident or injury caused by incorrect power supply.
Ensure the product is used with rated load. HIWIN is not responsible for any damage, accident or
injury caused by improper usage.
Do not subject the product to shock. HIWIN is not responsible for any damage, accident or injury
caused by improper usage.
If an error occurs in the drive, please refer to Chapter 9 and follow the instructions for
troubleshooting. After the error is eliminated, power on the drive again.
Do not repair the product by yourself when it malfunctions. The product can only be repaired by
qualified technician from HIWIN.
HIWIN offers 1-year warranty for the product. The warranty does not cover damage caused by improper
usage (Refer to the precautions and instructions stated in this manual.) or natural disaster.
The maximum ambient temperature for the product is 55°C.
The drive can only be installed in the environment that the degree of contamination is below 2.
The rated input voltage of the product is 240V. The power supply voltage cannot exceed 240V, and the
short-circuit current cannot be over 5000A.
The drive provides neither motor over-temperature sensor, nor motor over-temperature protection.
The short-circuit protection of the drive cannot be used as a shunt-circuit protection. The shunt-circuit
protection should be selected based on US National Electrical Code (NEC) and local regulations.
Power off and wa
it at least five minutes before examining the drive. To avoid electric shock, please use a
multi-meter or a similar apparatus to check if the residual voltage between P and N terminals has dropped to
the safety level (50Vdc or lower).
To Next Page
Loading...
Need help?
General
