282. The SAN Volume Controller 2145-8A4
microprocessor bracket frame fully opened . 258
283. SAN Volume Controller 2145-8G4 system
board ..............260
284. The placement of the screws that secure the
SAN Volume Controller 2145-8G4 system
board ..............261
285. Serial and video ports on the SAN Volume
Controller 2145-8G4 .........261
286. Installing the microprocessor ......262
287. Estimating the position of the thermal grease
dots...............263
288. Complete set of nine thermal grease dots on
the microprocessor..........263
289. Right air baffle on the SAN Volume
Controller 2145-8G4 system board ....264
290. Connectors on the right front side of the SAN
Volume Controller 2145-8G4 system board . . 265
291. Left air baffle on the SAN Volume Controller
2145-8G4 .............266
292. Connectors on the SAN Volume Controller
2145-8G4 system board ........266
293. Attaching the mounting plates ......269
294. Power cable clips ..........270
295. 2145 UPS-1U power cable-retention bracket
hardware .............271
296. 2145 UPS-1U power cable-retention bracket 271
297. 2145 UPS-1U power cable-retention bracket 272
298. The 2145 UPS-1U front-panel assembly 273
299. 2145 UPS-1U (rear view) ........273
300. Removing the 2145 UPS-1U front panel 274
301. The 2145 UPS-1U internal-battery connector 274
302. The 2145 UPS-1U internal battery connector
with protective tape .........275
303. Mounting screws for the 2145 UPS-1U 275
304. Installing the support rails for a 2145 UPS-1U
into the rack ............276
305. Mounting screws for the 2145 UPS-1U 277
306. Removing the 2145 UPS-1U front panel 277
307. The 2145 UPS-1U internal battery connector
with protective tape .........278
308. The 2145 UPS-1U with internal battery
connectors in place..........278
309. The 2145 UPS-1U cable retention bracket
connected to the 2145 UPS-1U ......279
310. 2145 UPS-1U (rear view) ........279
311. 2145 UPS-1U front-panel assembly ....279
312. Removing the front screws from the 2145
UPS-1U .............280
313. Removing the front rail on the 2145 UPS-1U 280
314. Removing the rear rail on the 2145 UPS-1U 281
315. Installing the support rails for a 2145 UPS-1U
into the rack ............281
316. Adjusting the rail depth on the 2145 UPS-1U 282
317. Securing the rear rail on the 2145 UPS-1U 282
318. Securing the front rail on the 2145 UPS-1U 283
319. Front and back panels for the 2145 UPS-1U 284
320. Removing the 2145 UPS-1U front panel 285
321. The 2145 UPS-1U internal battery connector
with protective tape .........285
322. Removing the 2145 UPS-1U battery ....286
323. Replacing the 2145 UPS-1U battery ....287
324. The 2145 UPS-1U internal-battery connector 287
325. Replacing the 2145 UPS-1U front panel 288
x IBM SAN Volume Controller Hardware Maintenance Guide
To Next Page
Loading...
Need help?
General
