3. Slide the back plate into the card guides, making sure not to trap or pinch any nearby wires or
cables.
4. Press firmly until the back plate is fully seated.
5. Rotate the air deflector (
1
in Figure 128 on page 124) into place, making sure not to pinch any
cables beneath it, and press it down firmly.
6. Reconnect the SATA cables to the system board. When you look from the front, SATA 0 is the drive
number for the left bay and SATA 2 is the drive number for the right bay.
Note: Make sure that the cable drive number matches the connector number on the system board.
The cables will cross over each other, as shown in Figure 130 on page 126.
1
2
svc00482
Figure 129. SAN Volume Controller 2145-8A4 power supply connectors
Chapter 2. Removing and replacing parts 125
To Next Page
Loading...
