To Next Page

To Previous Page

9. Turn on the node.

Replacing the SAN Volume Controller 2145-8A4 operator-information panel

You might have to replace the operator-information panel assembly on a SAN Volume Controller

2145-8A4 due to required maintenance.

Perform the following steps to replace the operator-information panel:

1. Connect the light panel cable

and the front USB cable

, shown in Figure 219, to the

operator-information panel board.

2. Guide the operator-information panel into position on top of the CD/DVD bay housing. Make sure

that the LEDs and the USB connectors are aligned with the openings in the bezel and that the holes in

the board align with the screw holes in the top of the bay housing.

3. Tighten the screws

to secure the operator-information panel onto the top of the CD/DVD bay

housing.

4. Replace the top cover. See “Replacing the top cover” on page 72.

5. Place the node in the rack. See “Replacing the SAN Volume Controller in a rack” on page 48.

6. Connect the power cable to the node and replace the cable-retention bracket. See “Replacing the

cable-retention bracket” on page 34.

7. Turn on the node.

Replacing the SAN Volume Controller 2145-8G4 operator-information panel

assembly

You might have to replace the operator-information panel on a SAN Volume Controller 2145-8G4 due to

required maintenance.

Perform the following steps to replace the operator-information panel:

1. From the front of the node, thread the light path ribbon cable through the panel housing in the node.

Figure 219. SAN Volume Controller 2145-8A4 operator-information panel

Chapter 2. Removing and replacing parts 199

Questions and Answers:

Need help?

Do you have a question about the IBM SAN Volume Controller and is the answer not in the manual?

IBM SAN Volume Controller Specifications

General