IBM SAN Volume Controller - The SAN Volume Controller 2145-8 G4; The SAN Volume Controller 2145-8 G4 SATA

9. Press the locking tab
1
, which is shown in Figure 123, and lift the back plate out of the node
slightly. Disconnect the power cable and remove the back plate.
1
Locking tab
2
Mounting channel
Figure 122. The SAN Volume Controller 2145-8G4 disk-drive backplane connectors
1
svc00306
2
2
Figure 123. The SAN Volume Controller 2145-8G4 SATA disk drive and back plate
120 IBM SAN Volume Controller Hardware Maintenance Guide