To Next Page

To Previous Page

a. Hold the battery so that the positive (+) side of the battery is facing toward the center of the

server.

b. Pull the retainer tab out of the way so that you can slide the battery into its socket.

c. Slide the battery down until it snaps into place, as shown in Figure 149.

2. Replace the top cover. See “Replacing the top cover” on page 72.

3. Place the node in the rack. See “Replacing the SAN Volume Controller in a rack” on page 48.

Removing the power supply

You must remove the SAN Volume Controller power supply if you intend to replace it.

Use the reference numbers in parentheses at the end of each notice, such as (C003) for example, to find

the matching translated notice in IBM Systems Safety Notices.

svc00110

Figure 148. Location of the CMOS battery on the SAN Volume Controller 2145-8F2 or the SAN Volume Controller

2145-8F4

svc00112

Figure 149. CMOS battery socket

140 IBM SAN Volume Controller Hardware Maintenance Guide

Questions and Answers:

Need help?

Do you have a question about the IBM SAN Volume Controller and is the answer not in the manual?

IBM SAN Volume Controller Specifications

General