IBM SAN Volume Controller - Cable Connected to the Disk Backplane in the SAN Volume Controller 2145-CF8

Figure 203 shows the boot-disk SAS cable connected to the disk backplane.
The boot-disk cable is shown disconnected from the disk controller so that you can see the
connectors on the back of the disk backplane more clearly.
1 Boot-disk SAS cable that is plugged into the disk-drive backplane to support drive bay 4
2 High-speed SAS-adapter cable that is plugged into the middle of the backplane to support
drive bays 0, 1, 2, and 3
Figure 204 on page 187 shows the boot-disk SAS cable connected to the disk controller.
1
2
Figure 203. Boot-disk SAS cable and the high-speed SAS cable connected to the disk backplane in the SAN Volume
Controller 2145-CF8
186 IBM SAN Volume Controller Hardware Maintenance Guide