6. Open the heat-exchanger-assembly release latch (
2
in Figure 246) to the fully open position.
7. Lift the side of the heat-exchanger assembly (
3
in Figure 246) that is closer to the middle of the
node, slide it toward the middle of the node slightly, and lift the entire assembly out of the node.
8. Open the microprocessor release latch to the fully open position.
Figure 246. SAN Volume Controller 2145-8A4 air baffle and heat-exchanger assembly
224 IBM SAN Volume Controller Hardware Maintenance Guide
To Next Page
Loading...
Need help?
General