TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
3-12
4. From the Terminal Menu, choose Preamble/Postamble.
PREAMBLE / POSTAMBLE
Preamble:
abc
Postamble:
\x0D\x0A
242XU.057
OK CANCEL
5. Move the cursor to the field for the preamble or postamble.
6. Type the control character, extended ASCII character, or escape character sequence
in the preamble or postamble field.
• To type a control character or extended ASCII character in the preamble or
postamble field, use this syntax:
\x
hh
where hh is the one or two-digit hexadecimal number for the control character or
extended ASCII character. For example, to enter ETX as a preamble, type:
\x03
To enter Ü (5250 Field Exit code) as the postamble, type:
\x9A
• To type an escape character (backslash) in the preamble or postamble field, use
the next table. The application ignores the first backslash (\) character and saves
the next character(s). For example:
Enter These
Characters Preamble/Postamble Saved
\\ \
\h h
\x x
\\k \k
\ no data
7. Press
or choose OK to save your changes and exit the screen.
To Next Page
Loading...
