Intermec Antares 2420 - Suspend;Resume Control

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
Co de 39
Nugget
9-108
Subnet Mask (continued)
*6* *7*
*6* *7*
*8* *9*
*8* *9*
3. Scan this bar code:
. (Period)
*.*
*.*
4. Repeat Steps 2 and 3 to set the next three numbers in the subnet mask address field.
After you scan the last address segment, go to Step 5. Do
not
scan the period after
the last address segment.
5. Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
Suspend/Resume Control
Purpose:
Controls the operation of the
L
key (suspend/resume). You can enable or disable the
L
key. When the
L
key is disabled, you cannot turn off the terminal. By default the
L
key
is enabled so that you can turn the terminal on and off.
Syntax:
EF
data
Acceptable values for
data
are:
0Enabled
1 Disabled
Default:
Enabled
Scan:
One of these bar codes:
Enable L Key Disable L Key
*$+EF0* *$+EF1*
*$+EF0* *$+EF1*