Intermec Antares 2420

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
nuggetf
code39
1-24
To use RF communications on the T2425, you need to:
1. Configure the DCS 300 (UDP Plus) or host (TCP/IP).
2. Configure the access point.
3. Configure the network parameters on the terminal.
Each step is described in the next sections.
Caution
Make sure all components with antennas are at least 1 feet (30 centimeters) apart
when power is applied. Failure to comply could result in equipment damage.
Conseil
Assurez-vous que la distance entre tous les éléments avec antennes soit d'au moins
un pied (centimètres) avant de faire la connexion avec l'alimentation électrique, faute
de quoi vous risquez d'endommager votre installation.
Configuring the DCS 300, Host, and Access Points
To use your T2425 in Intermec’s UDP Plus network, you must first install and configure
the DCS 300 and the access points. For help, see the DCS 300 System Manual and your
access point user’s manual.
To use your T2425 in a TCP/IP direct connect network, you must first install and
configure the access points. For help, see your access point user’s manual. You must also
set up your host to communicate with the devices in the RF network.
Note: You can use a T2425 communicating using UDP Plus and the DCS 300 in a
pass-through network. You establish a direct TCP/IP socket connection from the T2425
to the host through the server. For more information, see the DCS 300 System Manual.
Configuring the T2425 Network Parameters
You need to set these network parameters to begin using RF communications:
UDP Plus Network Parameters
Network Parameter Default Value
Network activate Disabled
Controller IP address 0.0.0.0
Terminal IP address 0.0.0.0
RF domain 0
RF security identification (ID) None (not set)