TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
Co de 39
Nugget
9-118
Timeout Delay (continued)
Notes: For COM1 only. To provide compatibility with earlier TRAKKER Antares firmware
versions, you can also use this syntax:
IEdata
where data is value from 0 to 7.
UPC/EAN
Purpose: Enables or disables the decoding of Universal Product Code (UPC)/European Article
Numbering (EAN) symbology. UPC/EAN are fixed length, numeric, continuous
symbologies that use four element widths. A terminal that is configured to decode EAN
bar codes can decode UPC, but the reverse is not true. UPC code is a subset of EAN
code.
To define the UPC/EAN symbology, you set up to seven digits. The fifth, sixth, and
seventh digits are optional. To set the sixth digit, you must set the fifth digit. To set the
seventh digit, you must set all seven digits.
Syntax: CEdata
where data must be 4 to 7 digits selected from this list:
First digit: 0 UPC-A/EAN-13 disabled
1 UPC-A/EAN-13 enabled
2 UPC-A only enabled
Second digit: 0UPC-E disabled
1UPC-E enabled
Third digit: 0EAN-8 disabled
1EAN-8 enabled
Fourth digit: 0 Supplementals are not allowed
1 Supplementals are allowed
Fifth digit: 0 Discard check digit
1 Transmit check digit
Sixth digit: 0 Discard number system digit
1 Transmit number system digit
Seventh digit: 0 Discard the leading zero for UPC-A
1 Retain the leading zero for UPC-A
To Next Page
Loading...
