Intermec Antares 2420

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
Co de 39
Nugget
9-54
Dynamic Host Configuration Protocol (DHCP)
Purpose: If your DCS 300 is operating as a DHCP client, its IP address will change each time it is
turned on. By enabling DHCP on the T2425, the terminal can locate and use the
DCS 300’s new IP address. The terminal’s IP address stays constant and must be
assigned to the terminal by your system administrator.
Before you can enable DHCP on the T2425, you need to configure the network
parameters for the T2425, including the Controller IP Address. The IP address does not
need to be the actual IP address for the DCS 300, since the T2425 will locate and reset
the IP address after you enable DHCP.
Note: DHCP is supported in the TRAKKER Antares firmware version 3.20 or later.
Syntax: NIdata
Acceptable values for data are:
0 Disable DHCP
1 Enable DHCP
Default: Disabled
Scan: 1. One of these bar codes to disable or enable DHCP:
Disable DHCP Enable DHCP
*$+NI0* *$+NI1*
*$+NI0* *$+NI1*
2. To save the changes in flash memory, scan this bar code:
Save Configuration in Flash Memory
*.+1*
*.+1*