Intermec Antares 2420

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
Nugg
Co de 39
7-14
Hardware Configuration
Purpose: If you are discussing a problem with Intermec, you can use the Hardware Configuration
screen to tell the Intermec representative the exact version of hardware that was installed
on the terminal at the Intermec factory. You can also use this screen to see the radio
frequency and country code that are configured on the T2425.
Where Available: Hardware Diagnostics menu
Sample Screen:
242XU.142
HARDWARE CONFIG
Country Code:
America/ASI (80,01)
Display Type: 0
Display Rev.: 0
Display Cont: 32
Keypad Type : 0
Keypad Rev. : 0
Keypad Table: 0
[Enter] Next screen
[Esc] Exit
HARDWARE CONFIG
PCMCIA Type: 2
PCMCIA Rev.: 1
PCB Rev. : 1
Product ID : 2420
Serial # :
96080200430
[Enter] Next screen
[Esc] Exit
Definition: Press  to display the next screen of hardware information. If you are having a specific
problem with one system, such as the radio, note the hardware versions on the terminal
before contacting your local Intermec service representative.
The country code information on the Hardware Configuration screen is only valid when
the radio (Network Activate command) is enabled. If the radio is disabled, the country
code information is not valid. For help, see “Network Activate” in Chapter 9.
Note: The country code information does not apply to the T2420 since it does not have
a radio.