Intermec Antares 2420

Co de 39
Nugget
Configuration Command Reference
9-91
9
RF Inactivity Timeout
Purpose: Defines the amount of time the radio on the T2425 waits to go into a low power state. If
no data is sent or received within the RF inactivity timeout period set, the radio goes into
a low power state to conserve battery power. If you set a high value, the radio stays on
longer at a higher power rate and uses battery power at a faster rate.
Power Management Tip:
Intermec strongly recommends that you use the optimum RF
inactivity timeout of 5 seconds to preserve the main battery pack’s power.
Syntax: RY
data
Acceptable values for
data
are:
0 Radio never turns off
1-51 RF inactivity timeout in seconds multiplied by a value of 5
where
data
=1 sets a timeout delay of 5 seconds,
data
=2 sets a timeout delay of 10
seconds, and so on, up to
data
=51 for a timeout delay of 255 seconds.
Default: 5 seconds
Scan: To set the default RF inactivity timeout to 5 seconds, scan this bar code:
Default RF Inactivity Timeout
*$+RY1*
*$+RY1*
Or: To set the RF inactivity timeout:
1. Scan this bar code:
Enter Accumulate Mode / Set RF Inactivity Timeout
*+/$+RY*
*+/$+RY*
2. Scan a numeric value for
data
from these bar codes:
*0* *1*
*0* *1*
*2* *3*
*2* *3*
*4* *5*
*4* *5*