Intermec Antares 2420

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
Co de 39
Nugget
9-84
Postamble
Purpose: Sets the postamble that is appended to any data you scan with the terminal. Common
postambles include cursor controls such as a tab or a carriage return line feed.
You can set the postamble to use characters from the extended ASCII character set such
as the Field Exit code for 5250 TE. However, you cannot scan in extended ASCII
characters in the Postamble command. You need to use the TRAKKER Antares 2400
Menu System. For help, see “Entering ASCII Control Characters” in Chapter 3.
Syntax: AEdata
Acceptable values for data are up to 25 ASCII characters. If you enter the AE command
without data, the postamble is disabled. If you are entering quotation marks as data or
grouping configuration commands, you need to enclose the data within quotation marks
(see the example).
Default: No characters (disabled)
Scan: To disable the postamble, scan this bar code:
Disable Postamble
*$+AE*
*$+AE*
Or: To set the postamble to an ASCII character string:
1. Scan this bar code:
Enter Accumulate Mode / Set Postamble
*+/$+AE*
*+/$+AE*
2. Scan a value for data from the “Full ASCII Bar Code Chart” in Appendix B. The
postamble can be from 1 to 25 characters.
3. Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*