Intermec Antares 2420

Co de 39
Nugget
Configuration Command Reference
9-43
9
Controller IP Address
Purpose: Defines the IP address assigned to the DCS 300 in your network. An IP address is a
network level address you assign to each device in a TCP/IP network. The controller IP
address you set on the T2425 must match the address that is set on the DCS 300.
If you plan to enable DHCP (Dynamic Host configuration Protocol), you can set the
controller IP address to any valid IP address. The terminal will locate and reset the IP
address after you enable DHCP. For help, see “Dynamic Host Configuration Protocol”
later in this chapter.
Syntax: NC
n.n.n.n
where each
n
address segment is a number from 0 to 255. The controller IP address field
consists of four separate numbers, each separated by a period.
Note:
The RF network cannot be activated if the first address segment in the IP address
is set to 0, 127, or a number greater than 223.
Default: 0.0.0.0
Scan: To set the default controller IP address, scan this bar code:
Default Controller IP Address
*$+NC0.0.0.0*
*$+NC0.0.0.0*
Or: To set the controller IP address:
1. Scan this bar code:
Enter Accumulate Mode / Set Controller IP Address
*+/$+NC*
*+/$+NC*