Intermec Antares 2420

Co de 39
Nugget
Configuration Command Reference
9-57
9
Flash Memory Configuration
Purpose: Configures the use of the optional 2MB flash memory. If you have a terminal with the
4MB flash memory option, you can configure the extra 2MB of flash memory either as a
drive D or as a storage space for double-byte fonts. You can store up to 32 files on drive
D or store a 2MB double-byte font set. If you configure the flash memory as drive D, use
this drive to store large lookup tables and data files.
Note:
You can only configure 2MB of the 4MB of flash memory as a drive or to store
fonts. You cannot use the space for both. If you configure drive D, you cannot store a
font in flash memory.
Syntax: FF
data
Acceptable values for data are:
0 Configure flash memory for double-byte fonts
32 Configure flash memory as drive D
Default: Configure flash memory for double-byte fonts
Scan: 1. Scan one of these bar codes:
Configure Flash Memory for Double-Byte Fonts
*$+FF0*
*$+FF0*
Configure Flash Memory as Drive D
*$+FF32*
*$+FF32*
2. Scan this bar code to save the configuration change in flash memory:
Save Configuration in Flash Memory
*.+1*
*.+1*
3. Scan this bar code to boot the terminal and use the flash memory to store double-byte
fonts or as drive D:
Reset Firmware
*-.*
*-.*