Nugg
Co de 39
Reader Command Reference
8-21
8
Run Program
Purpose: Runs the specified program or application that is stored on the terminal. For help, see
Chapter 5, “Using Custom Applications.”
Note:
You cannot store and run applications from the RAM drive (E).
From Network: //
drive:filename
where:
// is the command to run an application.
drive:
indicates the drive where the application is stored. You must include the
colon (:) after the drive letter.
filename
is the application you want to run.
Keypad: In the TRAKKER Antares 2400 Menu System, choose System Menu and then choose
File Manager. Next, choose the drive where the application is stored.
Scan: 1. Scan this bar code label:
Enter Accumulate Mode / Run Program
*+///*
*+///*
2. Scan the bar code label(s) for the application you want to run. You can scan labels
from the “Full ASCII Bar Code Chart” in Appendix B. The label must use this
format:
drive:filename
3. Scan this bar code label to exit Accumulate mode and run the application.
Exit Accumulate Mode
*-/*
*-/*
Or: You can create your own bar code labels to run applications by creating a bar code in
this command format:
//
drive:filename
Example: To run the application
SHIPPING.BIN
, use this command:
//c:shipping.bin
To Next Page
Loading...
