Intermec Antares 2420

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
nuggetf
code39
1-14
Charging the Backup Battery
You must fully charge the backup battery. The main battery pack charges the backup
battery when required with the terminal turned on or off.
Note: The backup battery charger operates between 32°F and 104°F (0°C and 40°C). If
you are using the terminal in an environment that is outside this temperature range, the
backup battery will not charge.
To charge the backup battery
1. Install a fully charged main battery pack. For help, see “Installing the Main Battery
Pack” earlier in this chapter.
2. Leave the terminal turned off and let the main battery pack charge the backup
battery. The backup battery will be fully charged in approximately 18 hours. After
you finish charging the backup battery, the main battery pack still has most of its
power remaining.
Note: The backup battery charges enough within 20 minutes to operate the terminal.
However, the backup battery will only provide limited backup power if it is not fully
charged.
Turning On the Terminal for the First Time
Once the batteries are charged, you are ready to turn on the terminal.
Note: You must have a scan module or a serial module attached to turn on the
terminal.
To turn on the terminal
1. Press the L key on the top left of the keypad. The terminal runs POST (power-on
self test) and then the Boot Menu appears.
BOOT MENU
b - Boot System
l - Run Loader
q - Power Down
POWER DOWN IN 60 SEC
242XU.104