Intermec Antares 2420

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
Co de 39
Nugget
9-38
Configuration Commands Via Serial Port
Purpose: Lets you control the data the terminal receives through the serial port. You can set this
command to execute reader and configuration commands received through the serial port,
or treat all data as data without checking for special command syntax. There are three
options:
Disabled All data received through the serial port is treated as data. The terminal will
not execute reader or configuration commands sent or encoded in the data.
Enabled with TMF If the data is sent with the TMF (Terminal Message Format) header,
the terminal will check for and execute reader or configuration commands received
through the serial port. With TMF, you can execute reader and configuration commands,
or send and receive data about the current terminal configuration.
Enabled without TMF The terminal will check for and execute all reader and
configuration commands (i.e., Receive File reader command or Beep Volume change
configuration command).
Note: Before you can enable Configuration Commands Via Serial Port with or without
TMF, you must enable the EOM command.
Syntax: YTn.data
where n is:
1 COM1 port
3 COM3 port
4 COM4 port
Acceptable values for data are:
0 Disabled
1 Enabled with TMF
2 Enabled without TMF
Default: Enabled without TMF
Scan: One of these bar codes:
COM1 Commands Via Serial Port Disabled
*$+YT1.0*
*$+YT1.0*
COM1 Commands Via Serial Port Enabled With TMF
*$+YT1.1*
*$+YT1.1*