Intermec Antares 2420

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
Nugget
Co de 39
6-26
6. Push the new antenna onto the antenna connector until it fits flush and the opening
for the retaining ring is visible.
7. Insert the retaining ring into the opening.
8. Push the retaining ring down until it is locked in place.
9. Turn the T2425 over and adjust the angle of the antenna as needed.
Cleaning the Scan Module Window and Terminal Screen
To keep the terminal in good working order, you need to clean the scan module window
and terminal screen. Clean these surfaces as often as needed or when they are dirty.
To clean the scan module window and terminal screen
1. Press L to turn off the terminal.
2. Use a solution of ammonia and water.
3. Dip a clean towel or rag in the ammonia solution and wring out the excess solution.
Wipe off the scan module window and terminal screen. Do not allow any abrasive
material to touch these surfaces.
4. Wipe dry.