Intermec Antares 2420

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
Co de 39
Nugget
9-102
Serial Port Protocol
Purpose: Lets you set the protocol that the serial port uses to communicate with the connected
device. Communications protocols determine exactly how data is transmitted between the
terminal and the serial device. Each protocol has parameters that you can set, such as
baud rate and parity. Both the terminal and the serial device must use the same protocol
and parameter settings to communicate properly.
The terminal can communicate in these four protocols:
• Binary
• Configurable
• Master Polling
• Polling Mode D
Each protocol is described in Chapter 4, “Operating the Terminal in a Network.”
Syntax: YUn.data
where n is:
1 COM1 port
3 COM3 port
4 COM4 port
Acceptable values for data are:
0 Configurable
2 Polling mode D
8 Master polling mode D
12 Binary
Default: Configurable
Scan: To set the default serial port protocol, scan one of these bar codes:
Configurable Protocol for COM1 Configurable Protocol for COM3
*$+YU1.0* *$+YU3.0*
*$+YU1.0* *$+YU3.0*
Configurable Protocol for COM4
*$+YU4.0*
*$+YU4:0*