Co de 39
Nugget
Configuration Command Reference
9-61
9
Handshake
Purpose: Enables or disables the handshake event that is an affirmative acknowledge to a message
received through the serial port.
Note:
Before you can enable Handshake, you must configure the EOM command.
Handshake is also referred to as AFF (affirmative acknowledge) on other Intermec
devices.
Syntax: YJ
n
.
data
where
n
is:
1 COM1 port
3 COM3 port
4 COM4 port
Acceptable values for
data
are:
Disabled No ACK or NAK transmitted
Enabled Set to ACK (hexadecimal value of \x06)
Default: Disabled
Scan: One of these bar codes:
Note:
To scan these bar code labels, you must configure the terminal to use Code 39 in
Full ASCII mode. For help, see “Code 39” earlier in this chapter.
Disable Handshake for COM1 Enable Handshake (Set to ACK) for COM1
*/D/KYJ1.* */D/KYJ1.$F*
*$+YJ1.* *$+YJ1.$F*
Disable Handshake for COM3 Enable Handshake (Set to ACK) for COM3
*/D/KYJ3.* */D/KYJ3.$F*
*$+YJ3.* *$+YJ3.$F*
Disable Handshake for COM4 Enable Handshake (Set to ACK) for COM4
*/D/KYJ4.* */D/KYJ4.$F*
*$+YJ4.* *$+YJ4.$F*
Notes: For COM1 only. To provide compatibility with earlier TRAKKER Antares firmware
versions, you can also use this syntax:
PG
data
where
data
is disabled or enabled (set to ACK).
To Next Page
Loading...
