TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
Co de 39
Nugget
9-60
Flow Control (continued)
3. Scan the flow control setting:
No Flow Control CTS Checking
*0* *1*
*0* *1*
XON/XOFF Response XON/XOFF Control
*2* *3*
*2* *3*
XON/XOFF Response and Control CTS/RTS for DTE-DTE
*4* *5*
*4* *5*
4. Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
5. Repeat Steps 1 through 4 to set the flow control for another serial port.
Notes: For COM1 only. To provide compatibility with earlier TRAKKER Antares firmware
versions, you can also use this syntax:
ILdata
where data is a numeric value from 0 to 5.
To Next Page
Loading...
