Intermec Antares 2420

Co de 39
Nugget
Configuration Command Reference
9-93
9
RF Security Identification
Purpose: Defines the password you can set for secured transmission and receipt of data between
devices in the 2.4 GHz RF network. To communicate, all access points and T2425
terminals in the subnetwork must have matching security IDs.
Syntax: RS
data
Acceptable values for
data
are up to 20 ASCII characters. When you enter the RS
command without
data
, the RF security ID is disabled or set to no characters (blank).
Note:
You can only set the RF security ID with the 2.4 GHz RF network enabled. The
Network Activate configuration command must be configured to 2.4 GHz RF Network
before you can save any changes to the RF security ID command.
Default: No characters or blank (disabled)
Scan: To disable or set the RF security ID to no characters, scan this bar code label:
Disable RF Security ID
*$+RS*
*$+RS*
Or: To set the RF security ID to an ASCII character string:
1. Scan this bar code:
Enter Accumulate Mode / Set RF Security ID
*+/$+RS*
*+/$+RS*
2. Scan a value for
data
from the “Full ASCII Bar Code Chart” in Appendix B. The RF
security ID can be from 1 to 20 characters.
3. Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
Notes: If you view the RF security ID in the TRAKKER Antares 2400 Menu System, the actual
security ID does not display on the screen. The words (ID unchanged) indicate that the
password has not been changed in the current menu session. If you change the security
ID, you see the new password until you exit the Configuration Menu and update the
runtime configuration.