Intermec Antares 2420 - Network Port

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
Co de 39
Nugget
9-78
Network Port
Purpose: Defines the network port that the TCP/IP or UDP Plus network protocol uses for
communications in your 2.4 GHz RF network. In a TCP/IP network, set the network port
to the appropriate port for the application you are using on the T2425. The default
network port of 23 enables VT/ANSI Telnet communications. In a UDP Plus network,
the network port you set on the T2425 must match the network port that is set on the
DCS 300.
Syntax: NGdata
Acceptable values for data are any number from 1 to 65535.
Default: 00023 T2425 with TCP/IP
05555 T2425 with UDP Plus
Scan: To set the default network port for a T2425 with TCP/IP, scan this bar code:
Default TCP/IP Network Port
*$+NG23*
*$+NG23*
To set the default network port for a T2425 with UDP Plus, scan this bar code:
Default UDP Plus Network Port
*$+NG5555*
*$+NG5555*
Or: To set the network port:
1. Scan this bar code:
Enter Accumulate Mode / Set Network Port
*+/$+NG*
*+/$+NG*
2. Scan a numeric value for data from these bar codes:
*0* *1*
*0* *1*
*2* *3*
*2* *3*