Intermec Antares 2420 - RF Transmit Mode

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
Co de 39
Nugget
9-94
RF Transmit Mode
Purpose: Defines the transmit mode that the T2425 radio uses. There are three modes:
BFSK Binary Frequency Shift Key. A broadcasting method the radio uses that
lengthens the range, but halves the throughput. This method is switched when the RF
protocol on the terminal determines that communications are degrading.
QFSK Quad Frequency Shift Key. A broadcasting method the radio uses that shortens
the range, but doubles the throughput. QFSK is the method used under standard radio
conditions.
Auto The terminal radio automatically switches modes between BFSK and QFSK as
needed.
Note: Even if you set this configuration command, the T2425 radio will reset the
parameter as needed to maximize the broadcasting range and throughput.
Syntax: RTdata
Acceptable values for data are:
0 BFSK (Binary Frequency Shift Key)
1 QFSK (Quad Frequency Shift Key)
3 Auto
Default: BFSK
Scan: One of these bar codes:
Set RF Transmit Mode to BFSK Set RF Transmit Mode to QFSK
*$+RT0* *$+RT1*
*$+RT0* *$+RT1*
Set RF Transmit Mode to Auto
*$+RT3*
*$+RT3*