Intermec Antares 2420 - Maximum Retries

Co de 39
Nugget
Configuration Command Reference
9-69
9
Maximum Retries
Purpose: Defines the number of times the T2425 will attempt to send a disconnect request message
to the DCS 300. The T2425 sends connect and disconnect request messages to the
DCS 300 when you turn the terminal on and off.
Tip:
Intermec strongly recommends that you use the optimum setting of 7 retries.
Syntax: NR
data
Acceptable values for
data
are:
0 T2425 retries indefinitely
1-99 Number of retries
Default: 7
Scan: To set the default number of maximum retries, scan this bar code:
Default Maximum Retries
*$+NR7*
*$+NR7*
Or: To set the maximum retries:
1. Scan this bar code:
Enter Accumulate Mode / Set Maximum Retries
*+/$+NR*
*+/$+NR*
2. Scan a numeric value for
data
from these bar codes:
*0* *1*
*0* *1*
*2* *3*
*2* *3*
*4* *5*
*4* *5*
*6* *7*
*6* *7*